PULS SLZ11 Adapter

Introduction

SLZ10-14 adapters allow mounting PULS switched mode power supplies or other DIN rail units on the S7-300 rail, which differs from other rails. Thus, a separate DIN rail is not necessary anymore. The adapter consists of a mounting bracket which is put onto the S7-300 rail and fixed at the lower edge with two screws which are included. The DIN rail power supply or any other device can then be mounted on a DIN rail piece of sufficient length fixed on this mounting bracket. The adapters are available in various widths for different unit sizes (see table below).

Features

• DIN-Rail bracket for S7-300-Simatic-Rail, width of unit max. 50mm