Menu
Your Cart

Proxim ORiNOCO QB-9100 Wireless LAN Access Point

Proxim ORiNOCO QB-9100 Wireless LAN Access Point
  • Model: ORiNOCO QB-9100
$0.00
Ex Tax: $0.00
Over 40 Years in Business
Over 40 Years in Business
Successful track record across Canada
Full Engineering Services
Full Engineering Services
A powerhouse to provide consultation, training, and support
Strong Brand Portfolio
Strong Brand Portfolio
Top-notch products from superb global and local suppliers
Advanced Technologies
Advanced Technologies
From legacy and mainstream to advanced Industry 4.0

Introduction

The ORiNOCO QB-9100 products leverage Proxim’s extensive experience in both WLAN access points and wireless backhaul. The ORiNOCO QB-9100 products combine an ORiNOCO 2.4 GHz access point and a Tsunami Quickbridge® 5 GHz point-to-point backhaul radio into a single product. By using these products, end-users will be able to enjoy network and Internet access via the feature-rich ORiNOCO access point combined with a very high throughput (866 Mbps data rate) backhaul in a single unit. This combination of functionality in a single unit is designed to reduce the solution footprint (especially for city deployments where smaller is better), reduce initial capital expenditure costs, and reduce recurring site rental costs.

QB-9100 products can all be centrally managed with ProximVision™ Advanced, Proxim’s hybrid controller-network management solution. ProximVision Advanced gives network administrators tremendous flexibility and control of individual units in heterogeneous network environments, enabling rapid deployments by automating configuration processes, exhaustive software-based device configuration capabilities, and easy upgradability.


Certifications

  


Features

  • Radio #1: WORP®, Radio #2: 802.11b/g/n (Remote end only)
  • Radio #1 : Up to 633 Mbps @ 80 MHz, Radio #2 (Remote end only) : Up to 150 Mbps
  • Radio #1 : Two N-type Connectors with built-in Surge Protection, Radio #2 (Remote end only) : Two N-type Connectors with built-in Surge Protection

Access Point : Interfaces
Wireless Protocol Radio #1: WORP®, Radio #2: 802.11b/g/n (Remote end only)
Access Point : Radio Specifications
Frequency Radio #1 : 5.150 – 5.925 GHz (Subject to Country Regulations), Radio #2 (Remote end only) : 2.400 – 2.484 (Subject to Country Regulations)
Throughput Radio #1 : Up to 633 Mbps @ 80 MHz, Radio #2 (Remote end only) : Up to 150 Mbps
Other Radio #1 : Dynamic Channel Selection (DCS) based on interference detection, Dynamic Frequency Selection (DFS) based on radar signature , Automatic Transmit Power Control (ATPC) with EIRP limit support, Radio #2 (Remote end only) : Automatic Channel Selection (ACS)
Access Point : Antenna
Antenna Type Radio #1 : Two N-type Connectors with built-in Surge Protection, Radio #2 (Remote end only) : Two N-type Connectors with built-in Surge Protection
Access Point : Management
Remote Telnet and SSH, Web GUI and SSL, TFTP, SNMPv3
SNMP SNMP v1-v2c-v3, RFC-1213, RFC-1215, RFC-2790, RFC-2571, RFC-3412, RFC-3414, Private MIB
Other Syslog, sFlow™ agent, SNTP and local time, Spectrum analyzer
Access Point : Standards and Protocols
Synchronization IEEE 1588v2 Ethernet Synchronization
Access Point : Security
Encryption Radio #1 : AES 128, Radio #2 (Remote end only) : 802.11i/WPA2 and WPA Wireless Security with AES-128, TKIP or WEP
Authentication Radio #1 : Internal MAC Address Control List, Radius based Authentication, Radio #2 (Remote end only) : Enterprise/802.1x, Personal/ PSK (Pre Shared Key) or Open
Access Point : Network
Modes Radio #1 : Bridging (support LACP through external switches), Routing (RIP v2 and IP tunneling), Radio #2 (Remote end only) : Access Point
IP Stack IPv4 and IPv6 simultaneously
Gateway Features DHCP Server & relay, NAT with Std ALGs
VLAN 802.1Q: Management VLAN. Transparent, Access, Trunk and Mixed mode. QinQ double tagging
Access Point : Power Requirement
Power Input 36 to 57 VDC via Ethernet port1 (PoE), 12 VDC via Access port, Power should not be provided simultaneously on both ports
Power Output 48 to 57 VDC – 25 Watt max on Ethernet port2 (PoE – software controlled), 12 VDC on Access port
Power Consumption Local end: 17 Watt typical, remote end 23 Watt typical
Access Point : Physical Characteristics
Temperature OPERATING -40º to 60ºC (-40º to 140º Fahrenheit), STORAGE -50º to 70ºC (-58º to 158º Fahrenheit)
Humidity 100% relative humidity
Dimensions Packaged 9.84 x 8.66 x 2.83 in (250 x 220 x 72 mm)
IP Rating IP67
Weight (PACKAGED) 9.92 lbs ( 4.5 kg) / 10.91 lbs (4.95 kg)